GTO/PRO SL-1000B with Lock 12 volt single gate operator for slide gate.

The GTO/PRO SL-1000B with Lock is designed for chain link, tubular steel or ornamental iron single slide gates. The PRO SL-1000B with Lock will operate a gate up to 30 ft. long, weighing 500 lbs., and will allow a total opening of 20 ft. The PRO Slide Gate Operator will handle up to 400 cycles per day, depending upon length and weight of gate.

This operator is battery powered; the battery charge is maintained by either the AC Transformer (included) or the Solar Panel accessory. The battery acts as its own backup during a loss of power service and will provide power for many opening and closing cycles before needing a recharge.

The heavy duty, 14 V AC 40 VA transformer can provide enough power for continuous cycling! While solar panels are an option, and will provide many cycles per day, they will not provide enough power for continuous cycle duty. You must use the transformer for continuous cycle duty.

The GTO/PRO line includes operators for both single and dual installations. GTO/PRO slide gate operators have adjustable auto-close and obstruction sensing features.

The PRO SL-1000B with Lock includes: operator, AC transformer, 12 volt battery, control box with control board, receiver and antenna with 10 ft. cable, entry transmitter, mounting hardware, installation and safety manual, warning signs, and two year warranty.

GTO/PRO SL-1200B with Lock Second operator for GTO/PRO SL-1000B with Lock 12 volt slide operator.

The GTO/PRO SL-1200B with Lock works as a slave opener when installed with SL-1000B with Lock. Opens gates up to 30 ft long each side with up to a 40 ft opening.

The PRO SL-1200B with Lock includes:  second operator,  60 ft. connecting cable,  mounting hardware, installation and safety manual, warning signs, and two year warranty.

GTO/PRO SL-2000B with Lock 12 volt single gate operator for slide gate. (up to 1000 lbs.)

The GTO/PRO SL-2000B Handles gates up to 30' (9.1 m) long, with 20' (6.1 m) opening, up to 1000 lbs. (453.6 kg) each leaf.

DRIVE:

• Powered by a 12 volt motor with integral case hardened steel gear reduction to 90RPM. Generates 310 inch pounds torque at 12 volts. temperature rating of motor -30°F (-34°C) to +160°F (93°C)
• Opening time is one foot per second

POWER:

• The GTO/PRO SL-2000B system is powered by a 12 volt DC / 7.0 amp hour, sealed, rechargeable gel-cell battery.
• Battery charge is maintained by a 120 volt AC / 60 hertz input and 18 volt AC at 40 VA (2.9 amperes) output transformer rectified to 14 volt DC through the GTO Control Board. Control board fuses are 20 amps.
• Battery charge maintained by optional GTO Solar panel Charger: float voltage 14.5 volt DC output from a 19 3/8" (49.23 cm) x 15 1/4" (38.74 cm) silicon alloy panel. Generates minimum of 10 watts at 600 mA. Gated diode on the control board prevents battery discharge.
  

CONTROL:

• GTO microprocessor controlled board can be programmed to open left-to-right or right-to-left. Adjustable auto close, inertia and obstruction sensitivity. Temperature compensated circuits. Auto-memorization of digital transmitter code. Charging regulated circuit on control board. "Sleep draw" is 40 mA; 'active draw" is 5 to 13 amps.
• GTO remote-mounted RF-receiver tuned at 318 Mhz.
• Limit controls are mechanical. Normal open contact.
• FUlly compatible accessory terminal block provided connections for hold open loops, wands, intercoms, card readers, phone systems, etc.

GTO/PRO SL-2200B with Lock Slave Unit designed to work with PRO SL-2000B for dual gates.

Includes second gate operator, mounting hardware, battery and battery harness 60ft connecting cable, installation manual, safety instructions and warning signs.