|
Attachments for the SG24 Series Surface Grinders
Grinding StonesUsually comprised of silicon carbide molded and
baked (vitrified) with a clay binder. As the binder wears with use, the
sharp edges of the silicon carbide are exposed, further promoting as
aggressive grinding action.
Stone service life is proportional to slab material composition, the
resulting applied force (machine weight) and slab hardness. Coarse grit
stones remove material faster with corresponding shorter service life.
Vitrified stones are usually more productive than resin bond types and
exhibit less tendency to load up and clog.
Stones are available from super coarse C06 to the very fine polishing
types C120 and C180 used to grind terrazzo and marble floor surfaces.
ScarifiersHeat treated, high carbon flails are mounted in
reusable steel frames and used to break up hard surface deposits
including: varnish, paint, epoxy, fiberglass and grout. Weight is usually
added to the grinder to provide additional down force. When used on
concrete surfaces, the scarifiers will chip the concrete from around the
aggregate. The resulting profile will usually require grinding with stones
to achieve the required finish.
Clean Sweep® Rotary BrushSilicon carbide impregnated brush is
used to clean concrete and tiles, remove rubber marks, chemical stains and
discolorations. Other pads can also be used for cleaning terrazzo,
scrubbing or buffing all types of tile, as well as general cleaning and
polishing applications.
Scrape-R-Tach® Floor Coatings Removal SystemThe SCRAPE-R-TACH™
floor coatings removal system mounts quickly and easily to popular models
of General and EDCO surface grinders.
Twelve replaceable inserts efficiently remove a wide variety of
urethanes, epoxies, paints, and many other encrusted formations with
unequaled ease. Inserts are constructed from a construction grade of
tungsten carbide that resist damage and quickly rotate to provide eight
sharp scraping edges for maximum service life.
Lord™ elastomeric mounts allow the inserts to closely follow minor
variances in floor contours to achieve maximum material removal. The
special rubber material also minimizes the effects of damaging shock loads
to the grinder when anchor heads and other floor obstructions are
encountered. The SCRAPE-R-TACH™ floor coatings removal system. It can be
the practical solution to many of your floor preparation needs.
DIAM-A-TACH® Diamond Segment Grinding SystemThe DIAM-A-TACH™
floor coatings removal system mounts quickly and easily to popular models
of General and EDCO surface grinders.
A diamond segment system is an ideal solution for many demanding
surface grinding applications, including small concrete irregularities,
removing debris or rubber tire build-ups from industrial floors, and a
wide range of thin film coatings. The anti-clogging characteristics of
diamond segments make them ideal for removing thin layers of adhesives,
sealers, mastics, grouts, and floor coating materials. Segments can be
operated both wet or dry.
The unique offset mounting configuration promotes more uniform wear
patterns for the segments, with a corresponding increase in service life
over other configurations. The circular shape minimizes the damage
potential when direct contact with a surface obstruction is made.
Individual segments can be replaced in a matter of a few minutes with
simple hand tools. |
